Commercial
Commercial Glass & Storefront Door Repair
A storefront door opens a few hundred times a day. When the closer goes or the pivot wears, it stops being an inconvenience and becomes a door that will not secure at close of trade.
If this is urgent
Anything that stops you securing or trading
For a business these are the same problem. We prioritise getting you closeable, then get you trading.
- A front door that will not lock
- Broken storefront glazing
- Storm damage to an opening
- A door that will not close at all
If this can wait
Scheduled around your hours
Planned work gets fitted around trading wherever it can, including early, late or on a closed day.
- Closers that slam or will not latch
- Doors dropping on worn pivots
- Glazing you want upgraded
- Pre-season checks before June
What is actually wrong
Commercial failures are duty-cycle failures
The hardware is not weaker than domestic hardware. It is doing several hundred times the work.
01
The closer has failed
A commercial closer handles hundreds of cycles a day. When the hydraulic goes, the door either slams or stops latching — and a door that does not latch does not lock, which is a security problem rather than a maintenance one.
02
The pivots have worn
Narrow-stile aluminium storefront doors run on top and bottom pivots. As they wear the door drops, scrapes the threshold and starts racking the corner joints, which is the point at which it gets expensive.
03
The corner joints have loosened
An aluminium door is tie-rodded together at the corners. Once the door has been dragging, those joints work loose and the whole leaf goes out of square.
04
The glazing has gone
Large tempered panes in high-traffic positions take impact and thermal stress. They are always made to size, so securing comes first and glazing follows.
05
The back door is the real weakness
Steel service doors that have been kicked, forced and weathered. On most commercial buildings this is the opening we would fix first if you asked us to pick one.
The sequence
How we work around a business
Four stages, scheduled around trading rather than around our convenience.
Stage one
Make securable
Whatever it takes to let you lock up at close of trade today, even if it is temporary.
Stage two
Assess properly
Closer, pivots, frame square, threshold, locks and glazing. Commercial doors fail as assemblies and fixing one part is how you get called back.
Stage three
Quote for accounts
Written, itemised and formatted for a managing agent, an insurer or your own bookkeeping.
Stage four
Fit around trading
Early, late or on a closed day where the work allows it. Glazing follows once the glass is made.
Louisiana conditions
What Louisiana asks of a commercial opening
Historic frontages, heavy footfall and a hurricane season that affects every business decision.
Hurricane season runs half the year
From June to November, every commercial opening in Louisiana is a storm consideration. The businesses that cope best are the ones whose doors, closers and glazing were already sound in May rather than being looked at in August.
Historic frontages
The French Quarter, the Garden District, downtown Baton Rouge and the Main Streets of a hundred Louisiana towns hold original timber and cast-iron shopfronts, decorative transoms and glazing that cannot be reproduced. Repair in keeping is usually both the right answer and the permitted one.
Extraordinary footfall in hospitality
Restaurants, bars and shops in tourist districts push cycle counts through a single front door that ordinary commercial hardware is simply not rated for. Closers and pivots in those buildings need replacing on a schedule, not on failure.
Humidity on timber frontages
Louisiana damp works hard on older shopfront joinery, particularly at the base of mullions and thresholds where water collects and never properly dries. Add termites and the ground floor of an old commercial building needs watching.
Before we come out
What helps us most
Five things that get a business back to securable fastest.
- 01Whether you can currently lock the premises, and what time you close.
- 02The address, and whether there is a service entrance or rear access.
- 03What type of door it is — aluminium storefront, timber, glass or steel service door.
- 04Whether the problem is the closer, the lock, the glass or the door itself, as best you can tell.
- 05Who signs off the work and how you need it invoiced.
Coverage
Commercial glass and storefront door repair across Louisiana
A mobile service covering all sixty-four parishes. Pick your town below, or call and we will come to you.
Commercial Glass & Storefront Door Repair Across Louisiana
Questions
Commercial questions
Can you come out after hours?
Where the job requires it, yes. Securing work happens whenever it is needed; planned repairs we fit around your trading hours.
Our front door will not latch at close of trade.
That is a security problem and we treat it as one. It is usually the closer or a worn pivot, and both are repairable.
Do you do automatic doors or panic hardware?
No. Powered operators and certified exit hardware are specialist trades, and on something this consequential we would rather point you to someone than improvise.
Our building is in a historic district.
Then repair is usually both the right answer and the permitted one. We work in keeping with the frontage rather than replacing character elements with modern substitutes.
Can you glaze a shopfront the same day?
Securing, yes. Permanent glazing, rarely — commercial tempered glass is made to size, and after a storm the whole region is ordering at once.
Do you invoice businesses properly?
Yes. Written itemised quotes and invoices suitable for accounts, insurers or a managing agent.
Related
Other repairs we handle
Windows and doors are the whole business, so whatever has failed, it is on this list.
Next step
Your front door is the business
Free estimates across Louisiana, scheduled around your trading hours.