Sealed units
Foggy Window & Seal Repair
Haze trapped between two panes. It will not clear, it cannot be cleaned, and it does not mean the window failed — only the glass unit inside it.
If this is urgent
Rarely urgent
A fogged unit is a performance problem rather than a safety one. We will not pretend otherwise to get you booked in sooner.
- Fogging with water pooling on the sill
- A unit that has cracked as well as fogged
- Glass loose in the sash
- Visible rot in the frame beneath
If this can wait
Almost always this
Fogged units are best done together, by elevation, once you know how many have gone. That is substantially cheaper than one at a time.
- One or two hazy windows
- A whole elevation that has clouded over
- Units you want upgraded while they are out
- Anything you noticed last winter and forgot
What is actually wrong
What has actually failed
Understanding this is the difference between replacing a pane of glass and replacing a wall of windows.
01
The perimeter seal, and nothing else
A sealed unit is two panes bonded around a spacer with a sealed cavity between them. When that bead fails, moisture enters the cavity. The frame, the sash, the hardware and the opening are all completely unaffected.
02
The insulating value went with it
Once the cavity is open to outside air, the unit performs roughly like a single pane. In Louisiana, where the air conditioning carries most of the year, that is a real and continuous cost.
03
It will not dry out
People wait a season hoping it clears. It looks better on dry days and worse on humid ones, and in this state that means it mostly looks worse. The moisture is inside a bonded assembly and there is no way out.
04
Defogging does not fix it
Drilling and venting a unit removes the visible haze. It does not restore the seal or the gas fill. We do not offer it, and we would rather lose the work than sell it as a repair.
05
The glazing rebate may be wet too
If the beads or putty around the unit have failed, the sash underneath has been taking water. That gets checked and repaired before new glass goes in.
The sequence
What the job looks like
Two visits, a week or so apart, and nothing disturbed in between.
Stage one
Confirm it
Checking that it is a failed seal and not room-side or exterior condensation, which in a Louisiana summer is a genuinely common confusion.
Stage two
Measure
On site. Units are made to size, and we count how many have actually gone rather than how many you noticed.
Stage three
Specify
Clear, Low-E, obscure or laminated depending on the elevation and what you want from it. Safety glazing where code requires it.
Stage four
Fit
Beads out, old unit out, new unit bedded and beads back. Usually under an hour per window, with nothing else touched.
Louisiana conditions
Why seals fail early in Louisiana
The most humid state in the country is the hardest possible environment for a perimeter seal.
Humidity with nowhere to go
Louisiana air is close to saturated for much of the year. The moment a seal begins to fail there is an enormous supply of moisture waiting to get in, which is why fogging here often appears suddenly rather than creeping up over seasons.
Heat load on the glass
Sealed units expand and contract with temperature, and a south or west elevation in a Louisiana summer takes a punishing amount of it. If one side of your house has fogged and the others have not, that is why.
Exterior condensation is not the same thing
On a humid morning you will often see water on the outside of a cold pane, because the air conditioning has chilled the glass below the dew point. That means the glass is working. It is the opposite of a failed unit, and it gets misdiagnosed constantly.
Salt air in the coastal parishes
Near the Gulf, salt-laden moisture works on the spacer edge and the fixings around it. Units on exposed coastal elevations reach the end of their lives noticeably earlier than the same product inland.
Before we come out
What helps us most
Five things that make the quote accurate first time.
- 01How many windows are affected, and which elevations they are on.
- 02A photo taken from inside, with the light behind you, which shows haze clearly.
- 03Whether the haze is between the panes or wipes off one of the surfaces.
- 04Roughly how old the windows are, if you know.
- 05Whether there is any soft timber or staining on the sill beneath them.
Coverage
Foggy window and seal repair across Louisiana
A mobile service covering all sixty-four parishes. Pick your town below, or call and we will come to you.
Foggy Window & Seal Repair Across Louisiana
Questions
Fogging questions
Will a foggy window clear up on its own?
No. The seal has failed and moisture is permanently inside the cavity. It looks worse on humid days, which in Louisiana is most of them.
Is defogging a real repair?
It improves the view and nothing else. It does not restore the seal or the gas fill, so we do not offer it. Replacing the unit is the repair that holds.
Do I have to replace the whole window?
No. Only the sealed glass unit is replaced. The frame, sash, trim and hardware all stay exactly where they are.
There is water on the outside of my windows in the morning.
That is exterior condensation, and it means your glass is doing its job. Cold glass meeting humid Louisiana air. It is the opposite of a failed seal.
Several windows fogged at once. Is that normal?
Yes, and it usually means one elevation takes more sun. It is also the cheapest time to deal with them, since we are already there.
How long does it take?
Measuring is quick. The unit is made to size, so fitting happens on a return visit, usually under an hour per window.
Related
Other repairs we handle
Windows and doors are the whole business, so whatever has failed, it is on this list.
Next step
Clear the fog properly
Free estimates across Louisiana, and an honest answer about defogging.